Whale Shark [Large Rainbow]
Whale Shark [Large Rainbow]
Product Care
Product Care
3D printed items are created by heat & as such it's their biggest enemy: no dishwashers, heaters or windowsills or else they may warp.
You can clean them with warm soapy water, a toothbrush & leave to air dry.
None of our items are intended as toys. They contain small parts & may present a choking hazard. Please be gentle with them, keep them away from small children esp those under 3.
License
License
This design is commercially licensed from Layers In Green. Cody Rose customises & prints these in regional Australia from specially selected filaments on her Bambu Lab printers.
Is there anything sweeter than a massive thing made into a smaller thing??? Whale shark that you can hold in your hand...
These ones are approx 9cm long & are a single piece with flexible parts [Flexi]. The last photo shows them vs our small ones!
While we don't recommend going for a swim with them, they definitely are big fans of telly & will happily watch anything you pop on without complaining!
For more info, check out tabs above.