Mouse in a Teacup
Mouse in a Teacup
Low stock: 5 left
Couldn't load pickup availability
Product Care
Product Care
3D printed items are created by heat & as such it's their biggest enemy: no dishwashers, heaters or windowsills or else they may warp.
You can clean them with warm soapy water, a toothbrush & leave to air dry.
None of our items are intended as toys. They contain small parts & may present a choking hazard. Please be gentle with them, keep them away from small children esp those under 3.
License
License
This design is commercially licensed from Layers In Green. Cody Rose customises & prints these in regional Australia from specially selected filaments on her Bambu Lab printers.
Mice! The only better than a single Mouse is a matching sized Rainbow Teacup to keep it in!
These ones are approx 10cm long inc tail & are a single piece with flexible parts [Flexi]. Their body is only around 4.5cm of that! The Teacup is a rainbow gradient - it may vary from pictured but will be very close!
For more info, check out tabs above.
